What are the steps and methods of decoration and t

2022-07-22
  • Detail

Ceramic tile is a necessary floor decoration material in our home decoration. What is the process of decoration and tiling? We haven't known about it at ordinary times, so today we'll take a look at the relevant introduction of the decoration and tiling process

ceramic tile is a necessary floor decoration material in our home decoration. What is the process of decoration and tiling? We haven't known about it at ordinary times, so today we'll take a look at the relevant introduction of the decoration and tiling process

decoration and tiling process 1. Pre arrange according to the size of the floor tiles you buy and the size of the floor

decoration and tiling process 2. Before tiling, clean the base course and thoroughly clean the dust and sundries

decoration and tiling process 3. Snap lines before paving, and pop up cross lines on the ground to control the separation size of floor tiles

decoration and tiling process 4. Clean the back of pre selected tiles and soak them in water for more than 2 hours

decoration and tiling process 5. Check whether the datum line is standard. Measure 1.6m points and 1.2m points along the intersection. If the distance between the two points is 2.0m, it proves that the datum line is vertical and standard, and tiling can begin

decoration tiling process 6. Pave the first benchmark brick along the benchmark line (the tiling method refers to the nine steps of paving the floor tile), then the floor tiles pasted along the benchmark line will be horizontally and vertically arranged vertically. It is difficult to achieve the effect of regularity without pulling wires or inaccurate pulling wires

decoration tiling process 7. When tiling, cement mortar should be fully plastered on the back of ceramic floor tiles, and then tamped with a rubber hammer after paving. At the same time, check and correct with a level and wipe the cement mortar on the surface

decoration and tiling process 8. After 2 to 3 hours of tiling, wipe the joints with white cement, and use cement mortar with cement and sand =1:1 (volume ratio). The joints should be filled tightly, flat and smooth. Wipe the surface with cotton yarn

about the decoration and tiling process, I'll introduce it here. I hope it can help you. More decoration information is here. Please look forward to it

武汉妇科医院

青岛男科医院

成都甲状腺医院

Copyright © 2011 JIN SHI